Solderless Connector Installation Instructions

Step A1: pull out the black tray clip carefully. Note! Tray is the bottom of connector
Step A2: be sure positive of connector (red) is lined up to positive + on Ribbon Flex
Step A2: put the light strip in the space between the clip and connector
Step A3: push the clip in original position.
Note! Make your cut as close to solder tabs before placing in tray for best connection

Step B1: pull out the black tray clip of each side carefully
Step B2: put the light strip in the space between the clip and connector at one side
Step B3: put the light strip in the space between the clip and connector at the other side, and push the clip in original position.